Skip header
 

Top Page > Main Chapters > Installation > LCIT PB3110 (D538) > Installation Procedure

Installation Procedure

CAUTION

  • Turn off the main switch of the copier and unplug the power cord before you start the installation procedure.

  • You need two or more persons to lift the copier. The copier is highly unstable when lifted by one person, and may cause injury or property damage.

  • Do not lift the copier with the paper feed unit installed. The handle and grips may be damaged.

d352i102.png

  1. Remove all tapes and retainers in the LCT.

    d352i103c.png

  2. Grasp the handle [A] and grips [B] of the machine.

  3. Lift the copier and install it on the LCT [C].

    Note

    • Hold the handle [A] and grips [B] of the machine when you lift and move the machine.

    d352i104b.png

  4. Remove trays 1 and 2 of the machine.

  5. Fasten the spring washer screw [D].

  6. Reinstall all trays.

  7. Attach the securing brackets [E] (_screw.png x 1 each; M4x10).

    b800i101a.png

    Note

    • One of the securing brackets is used as a securing tool (the cutout [F] is used in step 5). But the cutout [G] is for attaching the tray heater. Therefore, attach the securing brackets [E] after installing the tray heater if you install the tray heater.

  8. Load paper into the LCT.

  9. Turn on the main power switch of the machine.

  10. Check the LCT operation and copy quality.