Skip header
 

Top Page > Main Chapters > Installation > 1 Bin Tray BN3080 (D536) > Installation Procedure

Installation Procedure

CAUTION

  • Unplug the copier power cord before starting the following procedure.

If the bridge unit (D386) or side tray (D542) has already been installed in the machine, remove it before installing 1 bin tray unit (D536). This will make it easier for you to do the following procedure.

  1. Remove all tapes.

  2. Open the right door of the machine.

    b803i102

  3. Remove the front right cover [A] (_screw.png x 1).

  4. Remove the inner cover [B] (_screw.png x 1).

    Note

    • Keep this screw for step 5.

    d414i103.png

  5. Install the 1 bin tray unit [C] (_connector.png x 1, _screw.png x 1, _clamp.png x 1 [This screw was removed in step 4]).

    b803i104.png

  6. Attach the tray support bar [D] to the tray [E] as shown, and then attach the end-fence [F].

    d389i105.png

  7. Install the tray [G] (with the tray support bar) in the machine (M3 x 16: _screw.png x 2).

  8. Reinstall the front right cover in the machine, and then close the right door of the machine.

  9. Turn on the main power switch of the machine.

  10. Check the 1 bin tray unit operation.