Installation Procedure

If this finisher will be installed on the D086 or D087 copier, the following options must be installed before installing this finisher.

- Bridge Unit (D386)

- Paper Feed Unit (D537) or LCT (D538)

1. Unpack the finisher, and then remove the stopper [A] and tapes ( x 1).

   

2. Install the front joint bracket [B], holder bracket [C] ( x 2 - M4 x 14), and rear joint bracket [D] ( x 2 - M4 x 14).

   

   • The holder bracket [C] must be placed outside the front joint bracket [B]. The holder bracket is provided with the bridge unit (D386).

1. Install the grounding plate [E] on the finisher ( x 2 - M3 x 8).

   

   • Use the screw removed in step 1 and the screw from the accessory box.

2. Open the front door [F] of the finisher, and then pull the locking lever [G] (1 knob screw - M3 x 8).

3. Align the finisher on the joint brackets, and lock it in place by pushing the locking lever.

4. Secure the locking lever (1 knob screw - M3 x 8).

5. Close the front door.

6. Install the copy tray [H] (1 knob screw - M4 x 10).

7. Connect the finisher cable [I] to the main machine below the right rear handle.

   

8. Attach the staple position decal [J] to the ARDF as shown.

9. Turn on the main power switch and check the finisher operation.