Skip header
 

Top Page > Main Chapters > Installation > Controller Options > SD Card Appli Move > Move Exec

Move Exec

The menu "Move Exec" (SP5-873-001) lets you move application programs from the original SD card to another SD card.

Important

  • Do not turn ON the write protect switch of the system SD card or application SD card on the machine. If the write protect switch is ON, a download error (e.g. Error Code 44) occurs during a firmware upgrade or application merge.

  1. Turn the main switch off.

  2. Make sure that a target SD card is in SD Card Slot 1. The application program is moved to this SD card.

  3. Insert the source SD card with the application program in SD Card Slot 2.The application program is copied from this source SD card.

  4. Turn the main switch on.

  5. Start the SP mode.

  6. Select SP5-873-001 "Move Exec".

  7. Follow the messages shown on the operation panel.

  8. Turn the main switch off.

  9. Remove the source SD card from SD Card Slot 2.

  10. Turn the main switch on.

  11. Check that the application programs run normally.