Skip header
 

Top Page > Main Chapters > Replacement and Adjustment > Image Adjustment > Erase Margin Adjustment

Erase Margin Adjustment

Note

  • Adjust the erase margin C and D only if the registration (main scan and sub scan) cannot be adjusted within the standard values. Do the registration adjustment after adjusting the erase margin C and D, and then adjust the erase margin A and B.

b222r505

  1. Enter SP2-109-003.

  2. Print out the test pattern (14: 1-dot trimming pattern) with SP2-109-003.

  3. Check the erase margin A and B. Adjust them with SP2-103-001 to -015 if necessary.

    • Leading edge: 0.0 to 9.0 mm (default: 4.2 mm)

    • Side-to-side: 0.0 to 9.0 mm (default: 2.0 mm)

    • Trailing edge: 0.0 to 9.0 mm (default: 4.2 mm)