When re-installing the pressure roller

1. Apply "Barrierta S552R" to the front shaft of the pressure roller at 2 mm from the notch [A], and to the rear shaft of the pressure roller at 2 mm from the edge [B]. (Apply the lubricant to half of the circumference of the pressure roller, as shown in the lower of the three above diagrams.)

   

2. Make sure that pressure roller bearing [C] at the front side is set as shown above.

Pressure Roller Stripper Plate Installation

When reinstalling the pressure roller stripper plate:

1. Set the springs [A] (front and rear) correctly as shown above.

2. Install the pressure roller stripper plate [B] in the fusing unit frame as shown above.

   

3. Turn the pressure roller stripper plate [B].

4. Hold the pressure roller stripper plate, and then install the pressure roller.

   • The pressure roller stripper plate is not supported before installing the pressure roller in the fusing unit frame. If you stop holding, the pressure roller stripper plate can fall down.