ARDF side-to-side, leading edge registration and trailing edge

A: Leading edge registration

Use A3/DLT paper to make a temporary test chart as shown above.

1. Put the temporary test chart on the ARDF. Then make a copy from one of the feed stations.

2. Check the registration. Check the leading edge and side-to-side registration. Adjust the following SP modes if necessary.

   Standard: 4.2 ± 2 mm for the leading edge registration, 2 ± 1 mm for the side-to-side registration. Use the following SP modes to adjust if necessary.

   SP Code	What It Does	Adjustment Range
   SP6-006-001	Side-to-Side Regist: Front	± 3.0 mm
   SP6-006-003	Leading Edge Registration	± 5.0 mm
   SP6-006-005	Buckle: Duplex Front	± 3.0 mm
   SP6-006-006	Buckle: Duplex Rear	± 2.5 mm
   SP6-006-007	Rear Edge Erase (Trailing Edge)	± 10.0 mm