Skip header
 

Top Page > Main Chapters > Installation > Anti-Condensation Heater Type A > Installation Procedure > For Installing the Tray Heater in D538

For Installing the Tray Heater in D538

  1. Remove the rear cover of the mainframe (_point.png step 1 in For Installing the Tray Heater in D537).

  2. Pull out the LCT drawer.

    Note

    • If the right tray comes out with the left tray, push the right tray into the LCT.

    b801r111.png

  3. Left tray [A] (_screw.png x 2)

    b801r112.png

  4. Remove the right tray [B] while pressing down the stopper [C].

    Note

    • When reinstalling the right tray, set the right tray on the guide rail and carefully push the tray in, making sure to keep the tray level.

    b801i250.png

  5. Install the tray heater [D] in the optional LCT (_screw.png x 1).

    b801i251.png

  6. Remove the two securing brackets [E] (_screw.png x 1 each), and the then rear cover [F] of the optional LCT (_screw.png x 2).

  7. Remove the harness cover bracket [G] (_screw.png x 1).

    g832i250b.png

  8. Pull out tray 2 from the mainframe.

  9. Replace the shoulder screw [H] with the washer screw [I], using the securing bracket [J] (_screw.png x 1).

    b801i252.png

  10. Connect the harness [K] to the connector [L] of the tray heater.

  11. Route the harness [K] as shown and clamp it with four clamps (_clamp.png x 4).

  12. Connect the harness [K] to the connector [M] of the mainframe.

  13. Reassemble the mainframe and optional LCT.

    b800i192a.png

  14. Reassemble the mainframe and optional paper feed unit.

  15. Attach the on/standby decal [N] to the right-hand side of the main power switch.