Polygon Mirror Motor and Drive Board

1. Laser optics housing unit [A] ( Laser Optics Housing Unit)

   

2. Polygon mirror motor cover [A] of the laser optics housing unit ( x 4)

   

3. Polygon mirror motor holder [A] ( x 2)

4. Polygon mirror motor [B] ( x 4, x 1)

After installing the polygon mirror motor:

• 1) Do the "Forced Line Position Adj. Mode c" (SP2-111-3).

• 2) Then do the "Forced Line Position Adj. Mode a" (SP2-111-1).

To check if SP 2-111-1 was successful, watch the screen during the process. A message is displayed at the end. Also, you can check the result with SP 2-194-10 to -12.

After you replace the motor, do the adjustments in the following section of the manual: Image Adjustment – Registration.