Laser Optics Housing Unit
Before installing a new laser optics housing unit, remove the sponge padding and the tag from the new unit.
A new laser optics housing unit has a bracket to protect the LD units. When you install the new unit, do not remove the bracket until near the end of the installation procedure (the correct time is stated in the manual).
This bracket protects a capacitor on the unit. If the bracket is removed too early, you could break the capacitor on the corner of the main frame when you install the new unit.
Related topics
Preparing the new laser optics housing unit
Before removing the old laser optics housing unit
Recovery procedure for no replacement preparation of laser optics housing unit
Removing the old laser optics housing unit
Installing a new Laser Optics Housing Unit
After installing the new laser optics housing unit
