Changing the Connection Method Level for the Media Feed

To make further adjustment, carry out the following procedure.

1. Press the [Standard Procedure] key.
2. Press [Selected Setting for Head Alignment].
3. Press [Media Feed Correction].
4. Press [Level Setting].
5. (Only when the ink configuration is 4C+W) Select the print layer that you want to change the connection method level for the media feed.
6. Select the print mode that you want to change the connection method level for the media feed.
7. Select the adjustment level from [Level 0], [Level 1], [Level 2], and [Level 3].
8. Press [Close].
   When the ink configuration is 4C, press [Close] three times.
   When the ink configuration is 4C+W, press [Close] five times.
9. Press [End].

The connection method for the media feed will be applied to the first printing job after these settings are configured.

When the problem persists, repeat the abovementioned procedure again. If the problem still persists after repeating the procedure, increase the print resolution or select unidirectional printing.