Insert the nuts [A] of the roll core holder [C] into the grooves [B] from the right edge of the stay, and then slide the roll core holder towards left to install the holder on the right side of the stay.
- Attach the roll core holder [A] with the harness and switch [B] to the right side of the stay.
- Carefully attach the roll core holder not to drop the small white rubbers [A] attached on the bottom of the holder. The absence of the rubber might lower the power of fixing the holder to the stay.
- Attach the roll core holder [A] with the harness and switch [B] to the right side of the stay.
Attach the other roll core holder to the left side of the stay, in the same way.
- Attach the retaining part (nut) [A] to the one side of the groove of the stay, and then attach the end cap [B].
In the same way, attach the retaining part and the end cap to the other side of the groove of the stay.
- Clean the grooves of the stay, and then check if there is no dust on the groove.