Initial Jam

Code	Timing of the Detection	How to Remove
01	The carriage jam display sensor attached to the carriage detects the foreign objects, or media touching.	Open the middle cover. Raise the media holding lever if necessary. Remove the foreign objects or the media. Lower the media holding lever, and close the middle cover. Media holding cleaning Cap cleaning Around the nozzle cleaning The under side of the jam sensor of the carriage cleaning
	Cutter is not positioned at the home position while the front registration sensor is ON.	When the cutter is not positioned at the right edge, remove the media, and then open/close the middle cover.
	Opening of the middle cover is detected.	Close the middle cover.
	The media holding lever is raised or the roll holder or the pre-heater cover is open.	Lower the media holding lever or close the covers. Open/close the middle cover.
	Media end is detected.	Open the middle cover. Raise the media holding lever if necessary. Remove the media. Lower the media holding lever, and then close the middle cover.

After remove the jam paper, the carriage returns to the home position.