1. Remove the cure heater. (Cure Heater)
  2. Remove the post guide plate. (Post Guide Plate)
  3. Remove the harness cover [A] of the right side of the main unit.
  4. Disconnect the connectors.

  5. Remove the stepped screws with washers.

    Do not remove this screw [A].

  6. Remove the post heater [A].

    When installing the post heater, make sure that there is no gap in the area [A].

    When installing the post heater, tighten the screws [A] first, and then tighten the screws [B].

    Make sure to set the wave washer [B] to the stepped screw [A].