1. Remove the roll core holder. (Roll Core Holder)
  2. Remove the exterior covers [A] and [B] of the roll core holder.
  3. Remove the fixing screws from the support plate [A].
  4. Remove the connector.
  5. Remove the gear [A].

  6. Remove the harness bracket [A].

  7. Remove the harness [A].

  8. Remove the fixing screws from the support plate [A].

    When attaching the roll core holder, make sure to use the correct screw for each position.

    • [A] : M3X6
    • [B] : M3X6 (Round point)
    • [C] : M3X8

  9. Remove the support stay [A] by moving it in the direction of the arrow.

    When installing the support plate, cover the bracket with the support plate from the bottom side [A], and then attach the upper side [B] as shown below by the arrow.

    When installing the support plate, make sure that the shafts [A] fit into the cutouts [B] of the support plate.

  10. Remove the paper output motor [A].

  11. After replacing the paper output motor, adjust paper feed alignment. (Paper Feed/Roll-up Alignment Adjustment)