1. Remove the right side upper cover. (Removing the Right Side Upper Cover)

  2. Remove the right side lower cover. (Removing the Right Side Lower Cover)

  3. Remove the rear right cover. (Removing the Rear Right Cover)

  4. Remove the controller box right cover 1-3 on the rear side of the main unit. (Connecting the Connectors between the Roll Holders and Machine)
  5. Disconnect the connectors of the operation panel unit on the GAU.
  6. Remove the waste ink bottle [A], and then close the lid.
  7. Insert the cap [A] into the waste ink tube.
  8. Pull up the waste ink tube [A] to the inside of the main unit through the hole of the right bottom cover.
  9. Remove the screws which fix the operation panel unit [A].
  10. Remove the operation panel unit [A] from the cutouts of the right bottom cover, and then lay it on the ink receiving port cover.
  11. Disconnect the connector of the internal ventilation fan [A].
  12. Remove the right bottom cover.
    • Front side

    • Rear side
  13. Open the clamps to release the harnesses [A].
  14. Remove the fixing screws from the rear side [A] of the operation panel unit.
  15. Open the clamps to release the harnesses [A].
    • Pro L5160
    • Pro L5130
  16. Remove the fixing screws from the top side of the operation panel unit.
  17. Pull out the harnesses [A] from the cutout of the bracket and remove the operation panel [B].