Installation Overview

This machine can be used with 4C (C, M, Y, K) or 4C+W (C, M, Y, K, W) ink configuration. But the machine is in the state of 4C model with the factory-default setting. Therefore, if the customers use the machine in the state of 4C+W model, the setting needs to be changed to 4C+W model when installing the machine.

Confirm the ink configuration that customer uses, and install as the following flow chart.

Installation Flow

No.	Operation Item	4C
1	Unpacking Procedure
2	Installing the Printer Stand
3	Connecting Printer Stand with the Main Unit by Using Grips or a Forklift
4	Removing Exterior Orange Tapes
5	Removing the Left Front Cover, Left Side Upper Cover, Left Side Lower Cover, and Rear Left Cover Removing Exterior Orange Tapes Removing the Left Front Cover Removing the Left Side Upper Cover Removing the Left Side Lower Cover Removing the Rear Left Cover
6	Installing the Left Bottom Cover
7	Removing the Right Side Upper Cover, Right Side Lower Cover, and Rear Right Cover Removing the Right Side Upper Cover Removing the Right Side Lower Cover Removing the Rear Right Cover Removing the Supporting Screws from the Carriage Unit
8	Removing the Supporting Screws from the Carriage Unit
9	Installing the Right Bottom Cover
10	Installing the Operation Panel
11	Removing the Sealing Screw from the Ink Receiving Port
12	Removing the Supporting Sponge from the Carriage Unit
13	Removing the Protecting Seat of the Middle Cover
14	Installing Post Guide Plate and Cutter Unit
15	Installing the Cure Heater
16	Attaching the Media Holding Lever
17	Removing the Bracket Used for the Bar to Carry
18	Installing the Roll Holder/Roll Core Holder
19	Installing the Waste Ink Bottle
20	Level Adjustment
21	Paper Feed/Roll-up Alignment Adjustment
22	Measuring the Head Height and the Jam Detection Feeler Height
23	Installing the Power Cord and its Bracket
24	Attaching the Ink Cartridge Decal
25	Setting the Ink Cartridges to the Machine and the Flow of Initial Filling
26	Installing the Nozzle Cleaning Cartridge
27	Installing the Flushing Cartridge
28	Filling the Cleaning Liquid/ Discharging the Filling Liquid
29	Changing Color Variation SP ^*1	-
30	Changing the Joints of Branch Section and Connecting Circulation Tubes ^*1	-
31	Attaching the Circulation Tubes to Head Tank ^*1	-
32	Initial Ink Filling
33	Damper Air Purge
34	Setting the Media
35	Nozzle Check Pattern Printing/Checking
36	Colorimetric Sensor Adjustment: Adjustment of Sub-scan Direction Feed Amount
37	Colorimetric Sensor Adjustment: Auto Gap Adjustment
38	Date Settings
39	Time Zone/Summer Time Settings
40	Network Setup
41	@Remote Settings
42	RIP Server Setup
43	SMC Report (Storing the Setting Value of SP Code)
44	Updating the Firmware
45	Checking the Output
46	Moving the Machine
47	Attention Light Type C2 (option)
48	Operation Instruction

*1: Operation for 4C+W model. The factory default setting is for 4C model. If customers use the machine in the state of 4C+W model, the setting needs to be changed to 4C+W model when the machine is installed.