1. Remove the controller box right cover 1-3. (Connecting the Connectors between the Roll Holders and Machine)
  2. Release the harnesses.

  3. Remove the ground cable [A].

  4. Disconnect the connectors of the roll core holder.
  5. Remove the brackets [A].
  6. Remove the end caps [B] from the both sides of the stay, and then remove the retaining parts [A].

  7. Remove the roll core holders [A] from the both edges of the stay.
    (The picture below shows the one side of the stay.)
  8. After replacing the roll core holder, adjust paper feed alignment. (Paper Feed/Roll-up Alignment Adjustment)