1. Hold the handle [A] and pull out the roll feed unit [B].
  2. Disconnect the harness connector [A] of the roll holder from the connector [B] of the paper feed support stay.

  3. Remove the screws from the inside and outside of the paper feed support stay [A].

    Fasten the screw [A] on the outside of the paper feed support stay with the earth cable of the roll feed unit.

  4. Remove the paper feed support stay [A].


  5. Remove the snap rings.
  6. Remove the snap rings inside the paper feed support stay.
  7. Pull out the pin [A].

  8. Remove the roll feed unit set switch [A].

    When attaching the roll feed unit set switch, set the hole of the bracket to the position between the grooves [A] and [B] of the pin.

    The groove [A] is positioned inside the bracket. The groove [B] is positioned outside the bracket.

  9. After replacing the roll holders, adjust paper feed alignment. (Paper Feed/Roll-up Alignment Adjustment)